Product: VRM-XB1-XYZ

The VRM-XB1-XYZ COM Express Computer on Module is scalable from 1 GHz Ultra Low Voltage Celeron® M to 2.0GHz Pentium® M.

COM Express is an open PICMG® standard for Computer-On-Modules, based on new technologies such as PCI Express, Serial ATA and SDVO. Alternatively equipped with the Intel series of (LV) Pentium® M and ULV Celeron® M processors and up to 2GB RAM, the VRM-XB1-XYZ is a versatile COM Express basic form factor module, designed especially for systems which require high performance and low power consumption. Available with a variety of processors, starting with the 1GHz ULV Celeron® M 373 up to the 2.0GHz Pentium® M Dothan 760 with 533MHz FSB, the VRM-XB1-XYZ covers a wide range of industrial applications. The 915GM chipset is based on PCI Express Technology and has integrated a powerful dual screen graphics accelerator. The SDVO and VGA video interfaces allow for attachment of digital flat panel displays and analog monitors. The VRM-XB1-XXYZ is provided with a Gigabit Ethernet controller, and eight USB 2.0 ports for high speed communication. Four Serial ATA channels are available. In addition, an on-board CFA socket accommodates either a Compact Flash memory card or ATA Microdrive®. The dual slot DIMM socket is suitable to address up to 2GB interleaved (symmetric) dual channel memory. Typically, the VRM-XB1-XYZ will be combined with a custom specific carrier board. As a reference platform, V Rose provides the VRM-CL1, a CompactPCI 6U card with a rich set of additional I/O features. The VRM-XB1-XYZ COM Express module is the perfect choice for embedded applications that require a standard processor at the center of their design. OEMS can significantly improve their flexibility and reduce their total cost by adapting the open standards based architecture of COM Express.

Features:

Form Factor: PICMG COM Express R1.0 (COM.0), Basic Module form factor (125x95mm2), Pin-out Type 2
Processor: Designed for Intel® Pentium® M Micro FC-BGA 479 processors (90nm Dothan, 65nm Yonah Single Core), maximum junction temperature 100ºC
VRM-XB1-100: 1.0GHz ULV Celeron® M (Dothan 373), 400MHz FSB, 512KB L2 cache, 5W
VRM-XB1-140: 1.4GHz LV Pentium® M (Dothan 738), 400MHz FSB, 2MB L2 cache, 10W
VRM-XB1-200/1: 2.0GHz Pentium® M (Dothan 760), 533MHz FSB, 2MB L2 cache, 27W
Chipset: Intel i915 (Sonoma) chipset consisting of:
82915GM Graphics/Memory Controller Hub (GMCH) with Intel® Graphics Media Accelerator (GMA) 900
82801FB I/O Controller Hub (ICH6)
82802 Firmware Hub (FWH)
Memory: Dual 200-pin SO-DIMM socket, DDR2 533 SDRAM, 2 x 1GB maximum, symmetric dual channel capable
Video: Up to 2048x1536 pixel 16M colours @ 75Hz refresh rate (analog), up to 1600 x 1200 pixel 16M colours @ 60Hz (digital), dual screen support
Dual SDVO
Analog VGA
Dual LVDS
PEG PCI Express x 16 external graphics interface, multiplexed with SDV0
USB: 8 x USB2.0
Ethernet: 8 x USB2.0
PCIe to Gigabit Ethernet controller 10/100/1000Mbps
PATA (IDE): Ultra ATA/100 I/F ( Primary IDE), CompactFlash socket for a CFA ATA memory card or Microdrive® (Secondary IDE)
SATA- 4 x SATA-150
GPIO: 8 GPIO lines
Sound system: AC ’97 (external Codec)
PCI: ICH6 integrated 32-bit PCI bridge, 133Mbps CPCI master, 6 logical devices
PCI Express: 3-Lane PCie
BIOX: Phoenix BIOS
Intel graphics drivers
Intel networking devices
Power Requirements: +12V +0.5V tbd A max. @ 2.0GHz (tbd A WinXP idle mode)
Environmental Conditions
Operating Temperature: 0ºC … +60ºC
Storage Temperature: -40ºC...+85ºC, max. gradient 5ºC/min
Humidity 5%...95% RH non condensing
Altitude: -300m … +3000m
Shock: 15g 0.33ms, 6g 6ms / Vibration: 1g 5-2000Hz Lane PCIe / MTBF: tbd. EC Regulations: En55022,55024,60950-1
EC Regulations: EN55022, EN55024, EN60950-1 (UL60950-1/IEC60950-1)
Typical Performance Rating Measured with PCMark2002 under WindowsXP, 1GB DDR 533:
VRM-XB1-100: 1.0 GHz ULV Celeron® M (Dothan 373) tbd
VRM-XB1-140: 1.4GHz LV Pentium® M (Dothan 738) tbd
VRM-XB1-201: 2.0 GHz Pentium® M (Dothan 760) tbd

Request a Quote for Ordering Info

Read the Datasheet